Where to put 240mm radiator?

hello

i got a שלום

Black Ice® GT Stealth 240 XFlow Highest Peformance Radiator ,
with 2 silent 120 fans (17db)
however i have a thermaltake va7000 case and i don't know where to put it.
on the roof there is a 80mm fan and all the USB audio sockets, so i can't.
on the side where there are 2 92mm fan i can't put it because the VGA card and the other PCI cards block it.
on the rear i cant because it blocks most of my input/output sockets.

where can i put it?

thank u all

Well, don't know. We can't know if we don't know how your case is looking like, and where is space. That's up to you, whenever you've got space, mount it there. Maybe post some pics from your case, how is it looking like from inside, where is space and so on.

As a note, if you knew that there is no space in your case, why did you bought it?

I have my dual rad outside my case. case i got 3/8" tubing i could slide the tubes through the pci bracket area on the back of the case.

Then i have my fans on it, and their power connectors going in the same way as the tubes.

To push this further, i even have my case in a certain place under my desk, so the dual rad is on the other side, thus the 2x 120mm fans constantly get new cool air

hope this helps

- paul

ok so here are some pictures of my system and case, mean while as u can see i put the radiator o the small blocks (so i wont get all the dust from the floor) outside the computer

on the file u can see
my Reservoir (and passive cooling) and then the 240 radiator with the fans.
after that there is my case with the window and then the open case with the problem part of the PCI slots

i thought that i can out the radiator next to the 92 fans by druling threw the window but i am not sure anout that because i don't know how can i place it there (i need some support for this radiator) plus, i think the window might make a lot of noise due to the radiator and the 2 fans.

more pics

Well, where you want to put it, just glue the radiator there. No need for support... or you'd anytime mod your case. Make place for the radiator, also it'd be adviced a little cable managment, to improve airflow.

As for glue, you'd use Artic Silver Thermal Epoxy, it's awesome.

Most people mount their radiators on the back of the case on the outside, you should have room, you just take off the 92mm fan that you have blowing air out the back, or you could leave it and mount it there. And yes, a few, I take that back a few bags, of zipties would do you some good.

I know its a late response, but its a slow moving section of the forums.