|
|||||||||
|
|||||||||
|
|||||||||
 |
|||||||||
| |
||
|
|
|
|
|||||||||
|
|||||||||
|
|||||||||
|
|||||||||
| |
||
|
|
|
| |||||||||
 |
|
|
«
Previous Thread
|
Next Thread
»
|
Thread Tools | Search this Thread | Display Modes |
Dev Hardware Forums Sponsor:
|
|
|
January 11th, 2008, 09:29 AM
|
|||
|
|||
Athlon upgrade problem
Mobo: Epox 8k5a2+ Newest official bios (2003) Will support up to XP2800+
Purchased XP2400+ It wouldn't boot. I assumed the last CPU was bad because 1 pin was missing on a corner that wasn't a reference corner. RMA'd it back. New CPU does the same. On power up,CPU fan starts-post code goes to C1 (which I have no reference in my book) and then mobo speaker starts to beeb and CPU fan shuts down. Beeping continues for a few seconds even after all power is shut off. 1200 pot back in and it boots right back up. Any ideas would be helpful. Yes cmos was cleared
|
|
January 11th, 2008, 08:31 PM
|
|||
|
|||
|
Fixed
Don't bother yourselves responding to this thread. I found out the solution myself. It was a while because I had no help but that's ok
|
|
January 11th, 2008, 08:32 PM
|
||||
|
||||
|
could you sure your solution in case someone else in the future has the same problem? thanks!
__________________
How much net work could a network work, if a network could net work?
|
|
January 11th, 2008, 08:40 PM
|
|||
|
|||
|
I did something totaly out of the box-I put the XP 2400+ in WITH OUT clearing the cmos. Booted right up-recognizing wrong cpu and put me into cmos.Everthing gravy after that.
|
|
| Viewing: Dev Hardware Forums > HARDWARE > AMD Processors > Athlon upgrade problem |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
 |
|
|
Del.icio.us
Digg
Google
Spurl
Blink
Furl
Simpy
Y! MyWeb
Linear Mode
