Tweakmonster Dual 80mm Fan Bracket - Installation
(Page 3 of 5 )
The first step to installing the Tweakmonster Dual 80mm Fan Bracket is to install the fans. I chose an Evercool EC8025M12B 80mm two ball bearing fan and Cooler Master MGT8012LS 80mm sleeve fan.
You can use four screws to secure each fan, but only two are necessary.
The next step is installing the "mount" screws.
As you can see in the following picture, some AGP or PCI cards extend further than the bracket they are attached to that is screwed into the case. It is important for the fan bracket to be raised so as to fit without conflict, and these mounts raise it one full centimeter - enough to clear any AGP or PCI card.
Here is a final picture of the Tweakmonster Dual 80mm Fan Bracket installed.
Next: Testing >>
More PC Cooling Articles
More By KaoMAN
| Recommended by Dev Hardware |
|---|
|
/ 15 
