OCA Project Case - Bullet Window Installation
(Page 4 of 5 )
OCA Project CASEMOD featuring the Antec Plus View 1000AMG
Bullet Window Installation
Now that we have all the grunt work done, it's time to add a touch of finesse to this fine looking case.
Ready to install
Installing
Finished window install
The rubber edge can be a real pain to install depending on the size of the area you cut. I'm one of those paranoid few that normally cuts it too small which can make for a rough install. My way of thinking is, if it's too small, I can always cut more, but if I cut it too big to begin with, well I'm just up the creek w/out a paddle. And by the time I get around to fitting the window in, the last thing I want to do is take it back outside to cut on it some more, so either way, I'm just hatin' it.
Ok, so now that we have all that out of the way. I decided to put in the 92mm Blue LED fan from XO and the custom 92mm OCA Fan grill as well.
The finishing touches
I was very pleased with the outcome here and I also knew that when we put it in full LED action, it would look even better. These fans are not only easy on the wallet, they look damn good too. It'll be hard to ever go black to plain boring black fans after this, unless you just need specific ones, say for high speed action, or quietness. These particular ones from XO seem to lie somewhere in between and are perfect for what I need here.
Next up, PSU installation and cable modding.
Next: PSU Installation and Cable Modding >>
More Computer Cases Articles
More By SPeeD
/ 15 
